- 07 February, 2012
Mobile Network Test Seminars - 15 - 16 February, 2012
Southern Electronics - 08 March, 2012
UK Technology Day - 23 May, 2012
ElectroTestExpo
|
Ria Connect’s new IP67 CAT6A RJ45 ‘X-Synergy’ connectors, which are now available from Hylec-APL, have been developed to provide a solution for those looking to use the Ethernet in harsher industrial environments. While the Ethernet has become the default network communications format for PC based technology it has struggled to be adopted in the industrial environment and Ria believes that this solution could herald a wave of Ethernet enabled devices for both outdoors and the factory floor.
Industrial environments specify much higher requirements for connectivity. In a factory for example, plug connections often have to be protected against dust, humidity and other influences. In some applications, vibrations and high variations in temperature require additional measures to guarantee reliable contact and mechanical stability over long periods of time. These limitations and requirements have all been considered in the design and development of the new IP67 ‘X-Synergy’ connectors.
The key design feature of the ‘X-Synergy’ is a surface mount design (SMD) Edge Connector, connecting the modules to the PCB; compared to the use of normal THR RJ45 jacks, SMD assembly both saves time and cost for users. The Edge Connector means that there is no mechanical stress of the solder joints and helps to massively simplify the design and speed up installation and replacement times. The system also provides complete EMC signal shielding from the Cable to the PCB.
The ‘X-Synergy’ is based on different bulkheads and plug housings in industry standard variants V1, V4, V5 and V14 standardised according to ODVA and IEC 61076-3-106, all offering IP67 protection class. This level of protection means that it is both waterproof and dustproof and suitable for many industrial applications including: outdoor, marine and construction.
A particular challenge for industrial RJ45 connectors is the connection of optical signals in harsh environments. Each interface of a plug/jack combination is accompanied by data losses by reflexion or pollution for example. The so caused loss of signal energy results in a lower reach and signal reserve.
Direct connection of the SFP transceiver to the pc board by an edge connector offers an improvement of signal performance. This means one optical plug connection less compared to the general practice where the optical signal is carried from a jack in the housing wall via patch cable inside to the SFP transceiver. Thus X-Synergy offers in addition to the already launched RJ45 Ethernet modules for CAT6A 10/100 Mbit/s and 1 Gbit/s the possibility to use IP67 protected SFP transceivers by combining them with the proven bulkhead/plug variants.
Alex D’Arcy of Hylec-APL commented: “The Ria Connect X-Synergy range is a solution for those who are looking for reliable and flexible connectivity for their device design. The X-Synergy’s data cable is directly connected to the PCB, which means that installation is quick, mechanically sound and does not take up much space, while the connection is protected from wet weather environments, vibrations and exposure to chemicals.”
