|
PREMO has launched its new PBP19 Series, a family of inductors designed for DC/DC converters and telecom power supplies up to 500W, where the height of the 19" RAC system may be 0.25 U or 0.5 U, increasing power density and reducing telecom power systems sizes.
The PBP19 series with 7.4 mm height is offered in Tape & Reel for SMT technology and allows a maximum surface of 92% of total area in contact with the heat dissipating interface, either a coolplate or traditional heatsink. The thermal optimisation of components allows 10mJ energy storage with 2.8 microseconds cycles producing a lower dissipation of 2W and a high performance n> 95%.
The Telecom converters with soft-switching topologies (ZVS) allow increasing the switching frequencies from 250kHz up to 500kHz by using low Mosfet resistance. The DC resistance of the PBP19 series is typically 2mOhm, which perfectly fits in power semiconductors needs. This is achieved by implementing multilayer leadframe technology which eliminates round standard copper wire, skin effect and inefficiencies in the optimization of the winding window. The series allows configurations of 4 windings, with isolation against core above 500Vdc and overload saturation of 15% to 20% on the peak current.
PBP19 series is pin to pin compatible with other standard solutions, but eliminating the extra lateral pins, reducing 10% the PCB surface are and increasing the power density or reducing PCB costs.
- •New compact broadband amplifier operates across 0.5 GHz - 2.5 GHz frequency range
- •As the semiconductor market shifts into higher gear so the risk of counterfeits rises
- •Rutronik stocking compact thick film resistor with 1100 W power rating from Vishay
- •DLP Technology keeps Texas Instruments at top of MEMS market
